Hi all,
So after removing all rear braces and getting shot blasted, refinished, treating subframe etc….I started the reinstall earlier today.
The 6 x Main M12 bolts on the k-brace, all with new bolts ordered from JLR a few weeks ago.
Slowly slowly up to 133nm as per workshop info on topix and as confirmed on here in various topics.
5 bolts fine, 6th bolt up to around 120nm and BANG!……bloody bolt fails.
VERY luckily, the bolt had not snapped so I was able to remove. I had bought 8 bolts so had a spare and that went in fine (phew!)…see bolt pic below!
In a panic, I wondered if my torque wrench was buggered?……so knowing the wheel nuts were torqued to 125nm a few weeks ago, I set the torque on the wrench I had been using to 125nm and luckily it “clicked” on the wheel nut…so torque wrench ok.
Must have been a bad bolt? But I will pass by Jaguar dealer where I ordered bolts and show them.
ANYWAY…….just exhaust and bumper trim to do on Sat so here are few pics
Ps - I had a broken exhaust valve spindle, but contacted Mod-Stock. They were in my area on Thursday so brought a replacement back box down with new stainless butterfly valves fitted…and a huge saving over the £2279 JLR WOULD CHARGE!
Cheers to all
V6s Rear k-brace - nearly a disaster!
-
- You may also be interested in...
- Replies
- Views
- Last post
-
- 0 Replies
- 1162 Views
-
Last post by S1jor
-
- 2 Replies
- 511 Views
-
Last post by JamesO
-
- 15 Replies
- 575 Views
-
Last post by Moss
-
- 0 Replies
- 83 Views
-
Last post by cahuna
-
- 7 Replies
- 1374 Views
-
Last post by Pilot Pete