Now then folks,
I have a slight misalignment of the boot (trunk) on my P300 convertible. It's at the front edge on one side only and is noticeably lower the the other side. I've had a look but don't want to start adjusting anything and screwing it up.
From the images you can make out what the problem is. There is a small screw which lands on a small bracket/pad when closed. Is this what I need to adjust to raise this corner slightly?
Convertible Trunk alignment
-
- Posts: 1949
- Joined: Sat Apr 15, 2017 8:37 pm
No - that pad is just the stop once the hinge is adjusted.
You need to loosen the 2 or 3 bolts on the horizontal part of the hinge on the inside edge of the wing.
I suggest mark the current position with masking tape so you can revert to where it was.
Undo the bolts just a fraction so you can move it in a controlled manner. Nip them up, test and adjust more or less
Adjust the stop screw once you are all set correctly.
You need to loosen the 2 or 3 bolts on the horizontal part of the hinge on the inside edge of the wing.
I suggest mark the current position with masking tape so you can revert to where it was.
Undo the bolts just a fraction so you can move it in a controlled manner. Nip them up, test and adjust more or less
Adjust the stop screw once you are all set correctly.
2014 MY 3.0 V6S Roadster
Subtle enhancements to create the car I wanted from SVR nose cone, 400 series side skirts & customised 'design' rear bumper, to heated SVR steering wheel and more
Subtle enhancements to create the car I wanted from SVR nose cone, 400 series side skirts & customised 'design' rear bumper, to heated SVR steering wheel and more
-
- You may also be interested in...
- Replies
- Views
- Last post
-
- 2 Replies
- 747 Views
-
Last post by cj10jeeper
-
- 4 Replies
- 1126 Views
-
Last post by Carlosp
-
- 0 Replies
- 219 Views
-
Last post by Somerset Jim
-
- 7 Replies
- 2984 Views
-
Last post by mish38
-
- 1 Replies
- 336 Views
-
Last post by Madlil