Wheel spacers and offset

[Gasman2]

Hi troops planning to change my wheels to either vossen hf5 or concaver cvr5
The usual et for aftermarket are et40 fronts and et35 rear but I know a few have put 15mm or 20mm spacers on with no rubbing issues
So in theory if I did say et30f and et25 rear would thar fill out the arches a bit

[Alasdair63]

Hi Gasman,I have vorsteiner v FF 103 a ET32 and ET 50 and no need for wheel spacers

[Gasman2]

Hi is that et32 front tks

[Gasman2]

Are your wheels 20 or 21 inch and are they 10.5 or 11 inch tks

[Alasdair63]

They are 21x9 ET 32 Front 21x11ET50 on the rear , didn’t have a choice as that was the only size available for the F type. I like the vossen
HF5 that you mentioned, if you are planning on fitting the PB brakes they can supply you a template to check the clearance.

[Gasman2]

At present have been talking to concaver their cvr5 is very like the vossen
If I stick to 9x20 and 10.5x20 I can get a nice concave look
As my car is carpethian grey I am looking at platinum black for the wheels
My p b brakes should be shipping Monday
Gone for same kit as you
Red calipers and floating drilled and grooved discs

[itsajaaaag]

I'm going to get 20" Concaver wheels as well for my P450. I'm going to keep factory width of wheels but I'm thinking of choosing a lower offset to push the wheels out a bit. Question is how much smaller can the offset be so that the tyres don't rub on fender arches? Is 5 mm going to be even noticeable? Or should I go for 10 mm smaller offset without worrying about rubbing or that it's going to look ugly?

Gasman, which size did you choose and do you have any pics to show to help me get an idea?

[Gasman2]

Mine are 21inch and running 26 Offset at rear and 34 I think at front with no issues but it depends on wheel width as well

[Moss]

Hi Gasman,I have vorsteiner v FF 103 a ET32 and ET 50 and no need for wheel spacers

I’ve got to say that’s a stunning looking car, nicely set off with the yellow highlights.