Great - that just eliminates anything to do with front driveshafts, etc.Garymg wrote: ↑Sat Feb 10, 2024 9:23 amThanks. Its RWD.cj10jeeper wrote: ↑Sat Feb 10, 2024 9:13 am You don’t say if it’s 2/4WD, engine. All helps diagnose and eliminates various things
Prop shaft is a good one to check out as and very easy. They really do drone and are speed related.
Wheel bearings mentioned and can deteriorate very quickly. You tend not to notice then suddenly you can’t fail to hear it as you tune in.
Check if it’s load related on faster long corners
Very loud droning at the front
-
- Posts: 1949
- Joined: Sat Apr 15, 2017 8:37 pm
2014 MY 3.0 V6S Roadster
Subtle enhancements to create the car I wanted from SVR nose cone, 400 series side skirts & customised 'design' rear bumper, to heated SVR steering wheel and more
Subtle enhancements to create the car I wanted from SVR nose cone, 400 series side skirts & customised 'design' rear bumper, to heated SVR steering wheel and more
ts your neighbour bangin on about his tesla
Polaris White 380 rdstr, 2013, extnd leather,perf seats, cyclone 20”, Ferrari 458 spider 2015, Bianco avus,carbon pack, carbon seats, front lift, musician, biker,.
Money may not buy you happiness but I’d rather cry in a Jag than a bus. (or a 458)
Money may not buy you happiness but I’d rather cry in a Jag than a bus. (or a 458)
Glad you had it sorted and thanks for updating the thread. How much did it cost you and did you replace the bearing from one wheel only?
MY18 Manual P340 R-Dynamic RWD Coupe, Caldera Red on 19˝ Centrifuge wheels. Pzero. Mods: Reverse camera, interior/puddle lights and tinted windows.
The front bearing requires a complete hub. The total cost for the hub (genuine part) was £380 plus labour £60. A one-hour job. Interesting that the local garages took a stethoscope to both front wheels and said the bearings were fine. Apparently, no noise or movement on a ramp doesn't mean the bearing isn't knackered and can be a red herring. I considered doing both as a precaution but was told that was pointless as the other bearing could last 100K. They can wear independently.
-
- You may also be interested in...
- Replies
- Views
- Last post
-
- 0 Replies
- 1035 Views
-
Last post by gavall
-
- 3 Replies
- 7432 Views
-
Last post by Pigsy
-
- 6 Replies
- 1029 Views
-
Last post by scm
-
- 3 Replies
- 1134 Views
-
Last post by Ftypeblues
-
- 10 Replies
- 9047 Views
-
Last post by Tel